Example Flow: Landing Zone Identification
This Flow demonstrates how to identify your landing zones based on the deviations and your structure grids. The Flow is structured as follows:
- PointsInput >> This brings your deviations into the Flow
- ZoneLookup >> This brings in the headers and structure grids
- LandingZoneAnalysis >> This determines the landing zone, percent in zone, feet in zone, and evaluated lateral length
- PointsOutput >> Writes the results to a new points file.
The PointsInput lets you bring your deviation surveys into the Flow. The ZoneLookup determines the current zone at every depth step associated witha deviation survey (see screenshot above). In this tool all your zones must be in the correct stratigraphic order from shallowest to deepest.
LandingZoneAnalysis does the determination on the landing zone, percent in zone, feet in zone, and evaluated lateral length. Here the user should specify the Inclination above which the landing zone will be considered. E.g., a value of 80 means the tool will only consider segments of the lateral where the inclination is greater than 80 degrees.
The PointsOutput writes out a points file with the full results. This can always be filtered down to specific landing zones as needed using a PointsSelect.
Tips and Tricks
- You will need to have already processed your deviations.
- You will need to have already calcuated your structure grids.
- A geoscience license is required.
Related Insights
Quick Start Module
Purpose The Quick Start module is designed to help users quickly set dozens of common parameters by selecting a handful of basic options from dropdown menus. Parameters There are three parameters that are set on a zone-by-zone basis and two parameters that are set on a full-well basis. These are as follows. Discussion The parameters are linked to what are called named_defaults in the software. These are collections of defaults that can be set through assigning a single parameter.
Making Log Calculations in a Flow
This articles provides an overview of how to use a Flow to before basic log calculations. To do this, the following Flow tools are used: LogInput >> Bring the log data into the Flow LogMath >> Perform some calculation LogOutput >> Writes the log data to a new log database. There can be as many LogMath tools added to a flow as one would like, and they can be added to existing Flows ushc as a Log Clean-up Flow. The LogMath tool is extremely flexible.
Sample data to get started
Need some sample data to get started? The files below are from data made public by the Wyoming Oil and Gas Commission. These will allow you to get started with petrophysics, mapping, and decline curve analysis. Well header data Formation tops data Deviation survey data Well log data (las files) Production data (csv) or (excel) Wyoming counties shapefile and projection Wyoming townships shapefile and projection Haven’t found the help guide that you are looking for?